Hi all
I think I’ve found the problem for the DU mismatch, which seems to occur, mainly, when starting Oi4FS and when using the lights test switch. I’ve also noticed that the N1 Set & SPD Ref rotaries move too when a light test is executed.
I think the culprit is by having the two additional outputs included in the script, these being for the Take Off and Cabin Alt, which are not included on the Opencockpits MIP, but can be added to outputs 54 & 55 on the P2 connector.
Being as the MIP doesn’t have a great amount of inputs & outputs (mines single seat, so it has even less) I decided to create a test script for the MIP by adding 1 input and 1 output at a time. After all the inputs were scripted the problem wasn’t there. It’s when I started to add the outputs the problem returned once I added the Take Off & Cabin Alt. I didn’t delete them from the script, but commented them out….and viola, the problem was gone again.
Not too sure why this is happening, but my next test is to move them from the P2 connector and connect them to the output card, and update the script accordingly, and see what happens… For whatever reason, they seem to be causing a conflict with the PMDG events.
Regards
Ian
I think I’ve found the problem for the DU mismatch, which seems to occur, mainly, when starting Oi4FS and when using the lights test switch. I’ve also noticed that the N1 Set & SPD Ref rotaries move too when a light test is executed.
I think the culprit is by having the two additional outputs included in the script, these being for the Take Off and Cabin Alt, which are not included on the Opencockpits MIP, but can be added to outputs 54 & 55 on the P2 connector.
Being as the MIP doesn’t have a great amount of inputs & outputs (mines single seat, so it has even less) I decided to create a test script for the MIP by adding 1 input and 1 output at a time. After all the inputs were scripted the problem wasn’t there. It’s when I started to add the outputs the problem returned once I added the Take Off & Cabin Alt. I didn’t delete them from the script, but commented them out….and viola, the problem was gone again.
Not too sure why this is happening, but my next test is to move them from the P2 connector and connect them to the output card, and update the script accordingly, and see what happens… For whatever reason, they seem to be causing a conflict with the PMDG events.
Regards
Ian