I have changed the outputs for the TO & CA to outputs 16 & 17. I decided to change output 51 too, for the Speed brake Extended. Although this wasn't causing any problems, I decided not to use the P2 connector at all.
The result is perfect. The mismatch issue has gone. When executing a light test too, everything seems to be ok. As I have only a single side MIP, I don't have the F.O AFDS module, so I'm ok to use outputs 16, 17 & 18 which would otherwise be used on the F.O AFDS.
Hope this helps others with the same problem.
Regards
Ian
The result is perfect. The mismatch issue has gone. When executing a light test too, everything seems to be ok. As I have only a single side MIP, I don't have the F.O AFDS module, so I'm ok to use outputs 16, 17 & 18 which would otherwise be used on the F.O AFDS.
Hope this helps others with the same problem.
Regards
Ian